Send me the log ( three dot menu, copy log ) in DM, I will take a look. Some chips have extra channels for fans compared to the other ones in the same chip family, and not all individual chips SKU have their very specific spec implemented, if that makes sense. There are a ton of variety of a same chip, and in the driver library, they are all grouped together under a same file. As for your fan that doesn't show up, it's most likely a driver mapping issue. All headers are set to PWM control in the BIOS.Įach motherboard is kind of a different story, so I would try the different control mode for your fans in your BIOS and see if that makes a difference. When I first installed the software a while back, the pump would respond to the software, but now it no longer does. It's detected and the RPM's read just fine, but adjusting it in the software elicits no change anymore. I've also had an issue with the pump for my AIO not responding to your software. The bottom two read just fine and are linked to GPU temp, but the third one doesn't show up in your software at all. My fan setup is this: 1 rear exhaust fan on a chassis fan header, 2 top fans set to exhaust through my radiator, connected to a CPU fan header via a y-splitter, 3 front intake fans, each with their own chassis headers. My motherboard is an Asrock X570 Steel Legend Wi-Fi. Other softwares, as well as the BIOS, recognize the fan port as being populated and read the RPM's without issue, but that fan doesn't show up anywhere in your software. It just doesn't show up and I'm not sure why. The only issue I've run into is that it doesn't recognize the 5th PWM fan port on my system. I just wanted to say thank you for this software, as it does almost exactly what I've been looking for.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |